Other information:
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
This step is only necessary when installing a new component.
NOTE:
The PMI process must begin with the current BCM installed. If the
current BCM does not respond to the diagnostic scan tool, the tool may
prompt for As-Built Data as part of the repair.
A minimum of 2 RKE transm..
Check
NOTE:
Refer to the appropriate Section 303-01 for the specification.
Measure the cylinder bore at the top, middle and bottom
of piston ring travel in 2 directions as indicated. Verify the cylinder
bore is within the wear limit. The difference indicates the cylinder
bore taper. If the cylinder bore taper does not meet specification, bore
the cylinder to the next ..