Ford Fiesta: Climate Control System - General Information / Footwell Air Discharge Temperature Sensor - Vehicles With:
Electronic Automatic Temperature Control (EATC). Removal and
Installation
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Remove the HVAC control module.
Refer to: Heating, Ventilation and Air Conditioning (HVAC) Control
Module (412-00 Climate Control System - General Information, Removal and
Installation).
-
Disconnect the electrical connector and remove the footwell air discharge temperature sensor.
Loosen:
:
90°
Installation
-
To install, reverse the removal procedure.
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the push pin, release the clips and remove the RH floor console side trim panel...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the heater core and evaporator core housing - vehicles with:
EATC and remove the heater core and evaporator core housing - vehicles
with: EMTC ...
Other information:
Special Tool(s) /
General Equipment
Pick Hook
Interior Trim Remover
Removal
Release the clip and remove the rear door sail panel.
Use the General Equipment: Interior Trim Remover
Remove the interior door handle screw cover...
Materials
Name
Specification
Engine Oil - SAE 5W-20 - Synthetic Blend Motor OilXO-5W20-Q1SP
WSS-M2C945-B1
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the intake manifold...
Categories
Removal
NOTE:
Removal steps in this procedure may contain installation details.
WARNING:
Before beginning any service procedure in this
manual, refer to health and safety warnings in section 100-00 General
Information. Failure to follow this instruction may result in serious
personal injury.
Refer to: Health and Safety Precautions (100-00 General Information, Description and Operation).
Remove the wheel and tire.
Refer to: Wheel and Tire (204-04A Wheels and Tires, Removal and Installation).
read more