Ford Fiesta: Body and Paint / Body Repairs - General Information
Ford Fiesta 2014 - 2019 Service Manual / Body and Paint / Body Repairs - General Information
- Specifications
- Health and Safety Precautions. Description and Operation
- Straightening. Description and Operation
- Complete Panel Replacement/Partial Replacement. Description and Operation
- Sealer, Underbody Protection Material and Adhesives. Description and Operation
- Plastic Repairs. Description and Operation
- Noise, Vibration and Harshness. Description and Operation
- Impact of Insufficient Repair Quality. Description and Operation
- Corrosion Prevention. General Procedures
- Plastic Repairs. General Procedures
- Joining Techniques. General Procedures
- Welding Precautions. General Procedures
Side Airbag. Removal and Installation
Removal
WARNING:
The following procedure prescribes critical repair steps
required for correct restraint system operation during a crash...
Specifications
General Specifications
Item
Specification
Plastic front fascia paint maximum thickness
12 mils (300 microns)
Plastic rear fascia paint maximum thickness
12 mils (300 microns)
General Specifications
Item..
Other information:
Ford Fiesta 2014 - 2019 Service Manual: Liftgate Release Switch. Removal and Installation
Removal Remove the luggage compartment lid moulding - 5 door. Refer to: Luggage Compartment Lid Moulding - 5-Door (501-08 Exterior Trim and Ornamentation, Removal and Installation). Remove the liftgate release switch. Disconnect the liftgate release switch electrical connector. Release the retaining tabs. Remove the..
Ford Fiesta 2014 - 2019 Service Manual: Fuel Rail. Removal and Installation
Special Tool(s) / General Equipment 303-1567Sizer, Teflon SealTKIT-2010C-FLM 307-005 (T59L-100-B) Slide Hammer 310-205Fuel Injector Brush 310-206Remover, Fuel InjectorTKIT-2009A-FLM 310-207Installer, Fuel Injector Seal AssemblyTKIT-2009A-FLM Materials Name Specification Engine Oil - SAE 5W-20 - Synthetic Blend Motor..
Categories
- Manuals Home
- Ford Fiesta Service Manual (2014 - 2019)
- Service Information
- Front Subframe. Removal and Installation
- Engine Cooling - 1.6L EcoBoost (132kW/180PS) – Sigma
- General Information
- Climate Control System - General Information
Front Strut and Spring Assembly. Removal and Installation
Removal
NOTE: Removal steps in this procedure may contain installation details.
NOTE: This step is only necessary when installing a new component to the left-hand side.
Remove the nuts and position aside the remote brake fluid reservoir.Torque: 62 lb.in (7 Nm)
Remove the strut and spring assembly upper mount nuts. Torque: 22 lb.ft (30 Nm)
Copyright © 2025 www.fofiesta7.com