Ford Fiesta Manuals

Ford Fiesta: Supplemental Restraint System / Pinpoint Test - DTC: DD. Diagnosis and Testing

Ford Fiesta 2014 - 2019 Service Manual / Body and Paint / Supplemental Restraint System / Pinpoint Test - DTC: DD. Diagnosis and Testing

U0253:00

Normal Operation and Fault Conditions

The RCM uses information contained in messages from the APIM sent on the HS-CAN .


  DTC Fault Trigger Conditions


  DTC Description Fault Trigger Conditions
U0253:00 Lost Communication with Accessory Protocol Interface Module: No Sub Type Information This DTC sets if the RCM does not receive an expected message from the APIM .

Possible Causes

  • Network traffic
  • APIM
  • RCM

PINPOINT TEST A: U0253:00
NOTE: Most faults are due to connector and/or wiring concerns. Carry out a thorough inspection and verification before proceeding with the pinpoint test.
NOTE: Only disconnect or reconnect SRS components when instructed to do so within a pinpoint test step. Failure to follow this instruction may result in incorrect diagnosis of the SRS .
NOTE: Always make sure the correct SRS component is being installed. Parts released for other vehicles may not be compatible even if they appear physically similar. Check the part number listed in the Ford parts catalog to make sure the correct component is being installed. If an incorrect SRS component is installed, Diagnostic Trouble Codes (DTCs) may set.
NOTE: The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
A1 CHECK THE COMMUNICATION NETWORK
  • Ignition ON.
  • Using a diagnostic scan tool, carry out a network test.

Does the APIM pass the network test?
Yes GO to A2
No To diagnose no communication with the APIM ,
REFER to: Communications Network (418-00 Module Communications Network) .

A2 CHECK THE RCM (RESTRAINTS CONTROL MODULE) CONTINUOUS MEMORY DIAGNOSTIC TROUBLE CODES (CMDTCS)
  • Using a diagnostic scan tool, perform RCM self-test.
  • Using a diagnostic scan tool, clear RCM Diagnostic Trouble Codes (DTCs).
  • Wait 10 seconds.
  • Using a diagnostic scan tool, perform RCM self-test.

Is DTC U0253:00 retrieved again?
Yes GO to A3
No The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.

A3 RETRIEVE THE RECORDED DIAGNOSTIC TROUBLE CODES (DTCS) FROM THE RCM (RESTRAINTS CONTROL MODULE) SELF-TEST
  • Check for recorded Diagnostic Trouble Codes (DTCs) from the RCM self-test.

Is DTC U3003:16 or U3003:17 recorded?
Yes
REFER to: Pinpoint Test - DTC: FF (501-20B Supplemental Restraint System, Diagnosis and Testing).
No GO to A4

A4 RETRIEVE THE RECORDED DIAGNOSTIC TROUBLE CODES (DTCS) FROM THE APIM (SYNC MODULE) SELF-TEST
  • Using a diagnostic scan tool, perform APIM self-test.
  • Check for recorded Diagnostic Trouble Codes (DTCs) from the APIM self-test.

Is DTC U3003:16 or U3003:17 recorded?
Yes DIAGNOSE the battery voltage Diagnostic Trouble Codes (DTCs).
REFER to: Information and Entertainment System (415-00A Information and Entertainment System - General Information - Vehicles With: AM/FM/CD/SYNC, Diagnosis and Testing).
REFER to: Information and Entertainment System (415-00 Information and Entertainment System - General Information) .
No GO to A5

A5 CHECK FOR DTC (DIAGNOSTIC TROUBLE CODE) U0253:00 SET IN OTHER MODULES
  • Using a diagnostic scan tool, perform self-test for all modules.

Is DTC U0253:00 set in the ACM ?
Yes CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new APIM .
REFER to: SYNC Module [APIM] (415-00A Information and Entertainment System - General Information - Vehicles With: AM/FM/CD/SYNC, Removal and Installation).
REFER to: SYNC Module [APIM] (415-00 Information and Entertainment System - General Information) .
No CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new RCM .
REFER to: Restraints Control Module (RCM) (501-20B Supplemental Restraint System, Removal and Installation).


    Pinpoint Test - DTC: CC. Diagnosis and Testing

    U..

    Pinpoint Test - DTC: EE. Diagnosis and Testing

    U2300:55, U2300:64 Refer to Wiring Diagrams Cell 46 for schematic and connector information. NOTE: DTC U2300:55 is set in every new RCM installed until configuration data is successfully received from the IPC ...

    Other information:

    Ford Fiesta 2014 - 2019 Service Manual: Air Conditioning (A/C) Compressor Leak Detection. General Procedures


    Special Tool(s) / General Equipment Air Conditioning Service Unit Electronic Leak Detector Air Conditioning Adaptor Kit Leak detection Recover the refrigerant. Refer to Air Conditioning (A/C) System Recovery, Evacuation and Charging procedure in Group 412...

    Ford Fiesta 2014 - 2019 Service Manual: Specifications


      Material Item Specification Fill Capacity   Material: Motorcraft® High Temperature Nickel Anti-Seize Lubricant / XL-2 — —   Material: Motorcraft® Wheel and Tire Cleaner / ZC-37-A — — It..

    Categories

    Brake Master Cylinder. Removal and Installation

    Removal

    NOTICE: If the fluid is spilled on the paintwork, the affected area must be immediately washed down with cold water.

    NOTE: Removal steps in this procedure may contain installation details.

    All vehicles

    Remove the battery tray.
    Refer to: Battery Tray - 1.6L Duratec-16V Ti-VCT (88kW/120PS) – Sigma (414-01 Battery, Mounting and Cables, Removal and Installation).
    Refer to: Battery Tray - 1.6L EcoBoost (132kW/180PS) – Sigma (414-01 Battery, Mounting and Cables, Removal and Installation).
    Disconnect the vacuum tube from the brake booster and detach the routing clip.

    read more

    Copyright © 2024 www.fofiesta7.com