Ford Fiesta Manuals

Ford Fiesta: Body and Paint / Paint - General Information

Rear Side Member Section - 5-Door. Removal and Installation

Special Tool(s) / General Equipment Resistance Spotwelding Equipment 8 mm Drill Bit MIG/MAG Welding Equipment Spot Weld Drill Bit Materials Name Specification Seam SealerTA-2-B, 3M™ 08308, LORD Fusor® 803DTM -  Removal If required , dimensionally restore the vehicle to pre-accident condition...

Paintwork Defects and Damage. Description and Operation

Diagnosis and Damage Assessment Paint concerns, regardless of their causes, are part of the everyday work in the paint shop. Correct damage assessment and determination of the cause are preconditions for a professional resolution of a paint concern...

Other information:

Ford Fiesta 2014 - 2019 Service Manual: Transmission. Disassembly


Special Tool(s) / General Equipment 307-003 (T57L-500-B) Holding Fixture, Transmission Puller Punch   WARNING: Before beginning any service procedure in this section, refer to Safety Warnings in section 100-00 General Information...

Ford Fiesta 2014 - 2019 Service Manual: Pinpoint Test - DTC: S. Diagnosis and Testing


B1408:11, B1408:12, B1408:13 and B1408:1A Refer to Wiring Diagrams Cell 46 for schematic and connector information. Normal Operation and Fault Conditions The RCM continuously monitors the RH side air curtain circuits for the following faults: Resistance out of range Unexpected voltage Short to ground Faulted RH side air curtain If..

Categories

Ride Height Measurement. General Procedures

Special Tool(s) / General Equipment

Surface Gauge

Check

Ride Height Measurement - Front

NOTE: Make sure that the vehicle is positioned on a flat, level surface and the tires are inflated to the correct pressure. Vehicle should have a full tank of fuel.

Ride height = 2-3
Measurement 2
Measurement 3
Use the General Equipment: Surface Gauge

read more

Copyright © 2025 www.fofiesta7.com