Ford Fiesta: Electrical Distribution / Module Configuration
Configuration
WARNING:
Before beginning any service procedure in this
section, REFER to Safety Warnings in section 100-00 General Information...
System Operation
Programmable Module Installation (PMI)
PMI is a scan tool process which configures settings in a new module. Data used for the PMI
process is automatically downloaded from the original module and
stored when a scan tool session is started...
Other information:
Inspection and Verification
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).
Verify the customer concern by operating the starting system...
B007E:11, B007E:12, B007E:13 and B007E:1A
Refer to Wiring Diagrams Cell 46 for schematic and connector information.
Normal Operation and Fault Conditions
The RCM continuously monitors the driver safety belt retractor pretensioner circuits for the following faults:
Resistance out of range
Unexpected voltage
Short to ground
Faulted driver s..
Categories
Removal
NOTICE:
If the fluid is spilled on the paintwork, the affected area must be immediately washed down with cold water.
NOTE:
Removal steps in this procedure may contain installation details.
All vehicles
Remove the battery tray.
Refer to: Battery Tray - 1.6L Duratec-16V Ti-VCT (88kW/120PS) – Sigma
(414-01 Battery, Mounting and Cables, Removal and Installation).
Refer to: Battery Tray - 1.6L EcoBoost (132kW/180PS) – Sigma (414-01 Battery, Mounting and Cables, Removal and Installation).
Disconnect the vacuum tube from the brake booster and detach the routing clip.
read more