Ford Fiesta: Electronic Engine Controls - 1.6L EcoBoost (132kW/180PS) – Sigma / Turbocharger Boost Pressure (TCBP) and Charger Air Cooler Temperature (CACT) Sensor. Removal and Installation

Ford Fiesta 2014 - 2019 Service Manual / Engine / Electronic Engine Controls - 1.6L EcoBoost (132kW/180PS) – Sigma / Turbocharger Boost Pressure (TCBP) and Charger Air Cooler Temperature (CACT) Sensor. Removal and Installation

Removal

NOTE: Removal steps in this procedure may contain installation details.

With the vehicle in NEUTRAL, position it on a hoist.
Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation).

1. Disconnect the electrical connector.
1. Remove the retainer and the turbocharger boost pressure sensor.
  Torque: 53 lb.in (6 Nm)

Installation

To install, reverse the removal procedure.

Manifold Absolute Pressure (MAP) Sensor. Removal and Installation

Removal NOTE: Removal steps in this procedure may contain installation details. Remove the engine appearance cover. Disconnect the electrical connector, remove the retainer and the MAP sensor...

Manual Transmission, Clutch, Transfer Case and Power Transfer Unit

Other information:

Ford Fiesta 2014 - 2019 Service Manual: Body Control Module (BCM). Diagnosis and Testing

DTC Chart: Body Control Module (BCM) Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation). BCM DTC Chart DTC Description Action B1007:92 High-Beam..

Ford Fiesta 2014 - 2019 Service Manual: Communications Network - System Operation and Component Description. Description and Operation

System Operation System Diagram Item Description 1 DLC 2 PSCM 3 FCDIM (without touchscreen display) 4 HVAC module 5 ACM 6 GPSM (if equipped) 7 TCM (automatic transmission) 8 OCSM 9 PCM 10 ABS module 11 I..

Front Strut and Spring Assembly. Removal and Installation

Removal

NOTE: Removal steps in this procedure may contain installation details.

NOTE: This step is only necessary when installing a new component to the left-hand side.

Remove the nuts and position aside the remote brake fluid reservoir.
Torque: 62 lb.in (7 Nm)

Remove the strut and spring assembly upper mount nuts.
Torque: 22 lb.ft (30 Nm)