Ford Fiesta: Seatbelt Systems / Seatbelt Maintenance. General Procedures
Inspection
WARNING:
All seatbelt components must be inspected and corrected as
part of any collision repair. Inspect all seatbelt components as
prescribed by Seatbelt Procedure After a Collision found in Section
501-20A General Procedures of this manual. Failure to follow this
instruction may result in incorrect operation of the seatbelt system and
increase the risk of serious personal injury or death in a crash.
-
Periodically inspect the seatbelt assemblies for damage
and that they remain in correct operating condition, particularly if
they have been subjected to severe stress.
-
Before installing the new seatbelt assembly, inspect the
seatbelt retaining areas for damage and distortion. If the retaining
points are damaged and distorted, work the sheet metal back to its
original shape and structural integrity.
-
Install the new seatbelt(s) using the appropriate
instructions. Carry out the appropriate Functional Test procedure for
all seating positions.
Refer to: Seatbelt Systems (501-20A Seatbelt Systems, Diagnosis and Testing).
Cleaning
WARNING:
Do not bleach or re-dye the seatbelt webbing, as the webbing
may weaken. Failure to follow this instruction may increase the risk of
serious personal injury or death in a crash...
Inspection
WARNING:
All seatbelt components must be inspected and corrected as
part of any collision repair. Inspect all seatbelt components as
prescribed by Seatbelt Procedure After a Collision found in Section
501-20A General Procedures of this manual...
Other information:
Lubricants, Fluids, Sealers and Adhesives
Specifications
Motorcraft® DOT 4 LV High Performance Motor Vehicle Brake Fluid / PM-20
WSS-M6C65-A2 and ISO 4925 Class 6
Torque Specifications
Item
Nm
lb-ft
lb-in
..
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the push pin, release the clips and remove the RH floor console trim panel.
Disconnect the electrical connectors, remove the retainers and the blower motor speed control.
Installation
To inst..
Categories
Special Tool(s) /
General Equipment
Surface Gauge
Check
Ride Height Measurement - Front
NOTE:
Make sure that the vehicle is positioned on a flat,
level surface and the tires are inflated to the correct pressure.
Vehicle should have a full tank of fuel.
Ride height = 2-3
Measurement 2
Measurement 3
Use the General Equipment: Surface Gauge
read more