Ford Fiesta: General Information / Engine Cooling System Health and Safety Precautions. Description and Operation

Ford Fiesta 2014 - 2019 Service Manual / Service Information / General Information / Engine Cooling System Health and Safety Precautions. Description and Operation

WARNING: Always allow the engine to cool before opening the cooling system. Do not unscrew the coolant pressure relief cap when the engine is operating or the cooling system is hot. The cooling system is under pressure; steam and hot liquid can come out forcefully when the cap is loosened slightly. Failure to follow these instructions may result in serious personal injury.

Brake and Clutch Systems Health and Safety Precautions. Description and Operation

WARNING: Do not use any fluid other than clean brake fluid meeting manufacturer's specification. Additionally, do not use brake fluid that has been previously drained...

Gasoline and Gasoline-Ethanol Fuel Systems Health and Safety Precautions. Description and Operation

WARNING: Before working on or disconnecting any of the fuel tubes or fuel system components, relieve the fuel system pressure to prevent accidental spraying of fuel...

Other information:

Ford Fiesta 2014 - 2019 Service Manual: Roof Opening Panel Shield. Removal and Installation

Removal NOTE: Removal steps in this procedure may contain installation details. Remove the roof opening panel glass. Refer to: Roof Opening Panel Glass (501-17 Roof Opening Panel, Removal and Installation). NOTICE: Pull up on the center of the shade only enough to disengage the foot from the track...

Ford Fiesta 2014 - 2019 Service Manual: Steering Wheel and Column Electrical Components - Overview. Description and Operation

Steering Wheel and Column Switches Overview The steering wheel and column switches are located on the steering wheel, on or near the steering column. This enables the driver to control various vehicle functions and remain focused on driving. Depending on vehicle options, the steering column switches consist of: Left multifunction switch - mounted to the left side of the steering..

Ride Height Measurement. General Procedures

Special Tool(s) / General Equipment

Surface Gauge

Check

Ride Height Measurement - Front

NOTE: Make sure that the vehicle is positioned on a flat, level surface and the tires are inflated to the correct pressure. Vehicle should have a full tank of fuel.

Ride height = 2-3
Measurement 2
Measurement 3
Use the General Equipment: Surface Gauge