Ford Fiesta Manuals

Ford Fiesta: Electronic Engine Controls - 1.6L EcoBoost (132kW/180PS) – Sigma / Electronic Engine Controls - Overview. Description and Operation

Ford Fiesta 2014 - 2019 Service Manual / Engine / Electronic Engine Controls - 1.6L EcoBoost (132kW/180PS) – Sigma / Electronic Engine Controls - Overview. Description and Operation

Overview

The EEC system provides optimum control of the engine through the enhanced capability of the PCM . The EEC system also has an OBD monitoring system with features and functions to meet federal regulations on exhaust emissions.

The EEC system has two major divisions: hardware and software. The hardware includes the PCM , sensors, switches, actuators, solenoids, and interconnecting terminals. The software in the PCM provides the strategy control for outputs (engine hardware) based on the values of the inputs to the PCM .

The PCM receives information from a variety of sensor and switch inputs. Based on the strategy and calibration stored within the PCM , the PCM generates the appropriate output. The system is designed to minimize emissions and optimize fuel economy and driveability. The software strategy controls the basic operation of the engine, provides the OBD strategy, controls the MIL , communicates to the scan tool over the DLC , allows for flash EEPROM , provides idle air and fuel trim, and controls failure mode effects management (FMEM).

    Electronic Engine Controls - Component Location. Description and Operation

    E..

    Electronic Engine Controls - System Operation and Component Description. Description and Operation

    System Operation Refer to Powertrain Control/Emissions Diagnosis (PC/ED) manual. See Section 1 Description and Operation. Component Description Refer to Powertrain Control/Emissions Diagnosis (PC/ED) manual...

    Other information:

    Ford Fiesta 2014 - 2019 Service Manual: Front Drive Halfshafts. Diagnosis and Testing


    Inspection and Verification Verify the customer concern. Visually inspect for obvious signs of mechanical or electrical damage. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step If the cause is not visually evident, verify the symptom and refer to the Symptom Chart...

    Ford Fiesta 2014 - 2019 Service Manual: Front Control/Display Interface Module (FCDIM). Removal and Installation


    Removal NOTE: Removal steps in this procedure may contain installation details. Remove the instrument panel center upper trim panel. Refer to: Instrument Panel Center Upper Trim Panel (501-12 Instrument Panel and Console, Removal and Installation)...

    Categories

    Ride Height Measurement. General Procedures

    Special Tool(s) / General Equipment

    Surface Gauge

    Check

    Ride Height Measurement - Front

    NOTE: Make sure that the vehicle is positioned on a flat, level surface and the tires are inflated to the correct pressure. Vehicle should have a full tank of fuel.

    Ride height = 2-3
    Measurement 2
    Measurement 3
    Use the General Equipment: Surface Gauge

    read more

    Copyright © 2025 www.fofiesta7.com