Ford Fiesta: General Information / Battery and Battery Charging Health and Safety Precautions. Description and Operation
WARNING:
Batteries contain sulphuric acid, avoid contact with skin, eyes
or clothing. Wear safety goggles when working near the battery to
protect against possible splashing of the acid solution.
WARNING:
EYE CONTACT: If acid comes into contact with the eyes, flush
immediately with plenty of running water for a minimum of 15 minutes.
Seek immediate medical attention.
WARNING:
SKIN CONTACT: If acid comes into contact with the skin, flush
immediately with plenty of running water for a minimum of 15 minutes.
Seek immediate medical attention.
WARNING:
SWALLOWED: If acid is swallowed, rinse the mouth with plenty of
water and then drink plenty of water or milk. Do not induce vomiting.
Seek immediate medical attention.
WARNING:
Batteries normally produce explosive gases. Do not allow naked
flames, sparks or lighted substances to come near the battery.
WARNING:
When charging the battery shield your face and wear safety goggles. Provide adequate ventilation.
NOTICE:
Boost charging with excessive current or voltage above 16 volts will damage the battery.
WARNING:
Batteries contain sulfuric acid and produce explosive gases.
Work in a well-ventilated area. Do not allow the battery to come in
contact with flames, sparks or burning substances...
WARNING:
Do not use any fluid other than clean brake fluid meeting
manufacturer's specification. Additionally, do not use brake fluid that
has been previously drained...
Other information:
Materials
Name
Specification
Motorcraft® Metal Surface Prep WipesZC-31-B
-
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Drain the cooling system.
Refer to: Engine Cooling System Draining, Vacuum Filling and Bleeding
(303-03B Engine Cooling - 1...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Disconnect and position aside the vent tube.
Loosen the clamps and remove the air cleaner outlet pipe.
Torque:
44 lb.in (5 Nm)
Installation
To install, reverse the removal procedure...
Categories
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the brake shoes.
Refer to: Brake Shoes (206-02 Drum Brake, Removal and Installation).
Disconnect the brake tube fitting.
Torque:
159 lb.in (18 Nm)
Remove the bolt and wheel cylinder.
Torque:
106 lb.in (12 Nm)
Disconnect the brake shoe lever fitting and re
read more