Ford Fiesta: Starting System - 1.6L EcoBoost (132kW/180PS) – Sigma / Starter Motor Drive Gear and Flywheel Ring Gear Inspection. General Procedures
Activation
-
Refer to: Starter Motor (303-06B Starting System - 1.6L EcoBoost (132kW/180PS) – Sigma, Removal and Installation).
-
Check the wear patterns on the starter drive gear and
the flywheel or flexplate ring gear. If the wear pattern is normal,
install the starter motor.
Refer to: Starter Motor (303-06B Starting System - 1.6L EcoBoost (132kW/180PS) – Sigma, Removal and Installation).
-
If the starter drive gear and the flywheel or flexplate
ring gear are not fully meshing and the gears are scored or damaged,
install a new starter motor.
Refer to: Starter Motor (303-06B Starting System - 1.6L EcoBoost (132kW/180PS) – Sigma, Removal and Installation).
-
If necessary, install a new flywheel or flexplate.
Refer to: Flywheel (303-01B Engine - 1.6L EcoBoost (132kW/180PS) – Sigma, Removal and Installation).
Inspection and Verification
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation)...
Removal
WARNING:
Always disconnect the battery ground cable at the battery
before disconnecting the starter motor battery terminal lead...
Other information:
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
The AM / FM
/Satellite radio antenna cables are part of the vehicle wiring harness...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the instrument panel center upper trim panel.
Refer to: Instrument Panel Center Upper Trim Panel (501-12 Instrument Panel and Console, Removal and Installation)...