Ford Fiesta: Glass, Frames and Mechanisms / Rear Door Window Regulator Motor. Removal and Installation
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
LH side shown, RH side similar.
-
Remove the rear door trim panel.
Refer to: Rear Door Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
-
Remove the rear door window regulator motor.
-
Disconnect the rear door window regulator motor electrical connector and position aside the wiring harness.
-
Remove the screws.
Torque:
31 lb.in (3.5 Nm)
Installation
-
To install, reverse the removal procedure.
-
If the door is equipped with one touch up/down, carry out the power door window initialization.
Refer to: Power Door Window Initialization (501-11 Glass, Frames and Mechanisms, General Procedures).
Removal
NOTE:
LH shown, RH similar.
NOTE:
Removal steps in this procedure may contain installation details.
All vehicles
Remove the rear door trim panel...
Special Tool(s) /
General Equipment
300-AST1770EDeluxe Air Knife
AST405
Glass Removal Suction Cup
Materials
Name
Specification
Sika® SikaTack® MACH 60 / Sika® SikaTack® MACH 30 / Dow® BETASEAL™ Express
-
Sika Tack ASAP Urethane Adhesive
-
Dow Urethane One Step Glass PrimerBetaprime™ 5500/5500A/5500..
Other information:
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Recover the refrigerant.
Refer to: Air Conditioning (A/C) System Recovery,
Evacuation and Charging (412-00 Climate Control System - General
Information)
.
With the vehicle in NEUTRAL, position it on a hoist.
Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lif..
The B6 6-speed manual transmission is a fully synchronized transmission including reverse gear.
The 1st and 2nd gears are triple cone synchronized. The 3rd, 4th, 5th, 6th and reverse gears are single cone synchronized.
The
function of the transmission is to move the vehicle from a rest
position to motion. This is done by transferring the engine torque,
through the transmission, to the fr..
Categories
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the brake shoes.
Refer to: Brake Shoes (206-02 Drum Brake, Removal and Installation).
Disconnect the brake tube fitting.
Torque:
159 lb.in (18 Nm)
Remove the bolt and wheel cylinder.
Torque:
106 lb.in (12 Nm)
Disconnect the brake shoe lever fitting and re
read more