Ford Fiesta Manuals

Ford Fiesta: Wipers and Washers / Wipers and Washers - Overview. Description and Operation

Ford Fiesta 2014 - 2019 Service Manual / Body and Paint / Wipers and Washers / Wipers and Washers - Overview. Description and Operation

Overview

The windshield wiper/washer system is activated by the wiper/washer switch (also known as the steering column multifunction switch RH ). The following functions/features of the windshield wiper/washer system are:

  • Windshield wash
  • Mist wipe (single wipe)
  • Windshield wipers (low/high speed)
  • Intermittent wipers
  • Wiper activated exterior lamps (if equipped)
  • Rain sensitive wipers (if equipped)
  • Rear window wipe
  • Rear window wash

There are 6 intermittent settings to choose from for the rain sensitive wipers (if equipped) and the intermittent wipers.

There are 2 settings (off and on) to choose from for the rear window wiper operation.

    Wipers and Washers

    ..

    Wipers and Washers - System Operation and Component Description. Description and Operation

    System Operation System Diagram Item Description 1 Wiper/Washer Switch 2 Windshield Wiper Motor 3 Washer Motor 4 BCM 5 Rear Window Wiper Motor 6 Rain Sensor Windshield Wipers The windshield wipers operate only when the ignition is ON...

    Other information:

    Ford Fiesta 2014 - 2019 Service Manual: Supplemental Restraint System (SRS) Depowering and Repowering. General Procedures


    Depower NOTE: The SRS must be fully operational and free of faults before releasing the vehicle to the customer. Turn the ignition OFF. At the BCM , located behind the glove box, remove the BCM fuse 20 (10A). Refer to Wiring Cell 11 Fuse and Relay Information for schematic and connector information...

    Ford Fiesta 2014 - 2019 Service Manual: Catalytic Converter. Removal and Installation


    Special Tool(s) / General Equipment Cable Ties Removal NOTE: Exhaust fasteners are of a torque prevailing design. Use only new fasteners with the same part number as the original. Torque values must be used as specified during reassembly to make sure of correct retention of exhaust components...

    Categories

    Rear Wheel Speed Sensor. Removal and Installation

    Removal

    NOTE: Removal steps in this procedure may contain installation details.

    Remove the retainer and pull the rear splash shield outward.
    Disconnect the electrical connector and detach the wiring retainer.

    read more

    Copyright © 2025 www.fofiesta7.com