Other information:
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
LH side shown, RH side similar.
Remove the rear door trim panel.
Refer to: Rear Door Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
Remove the rear door window regulator motor.
Disconnect the rear door window regu..
Check
NOTE:
Refer to the appropriate Section 303-01 for the specifications.
NOTE:
The cylinder bore must be within the specifications for taper and out-of-round before fitting a piston.
Measure the cylinder bore in 2 directions at 79.75 mm (3.139 in) from block deck.
Make sure that the piston-to-bore clearance is within specifications.
..