Ford Fiesta Manuals

Ford Fiesta: Engine System - General Information / Engine - Overview. Description and Operation

Ford Fiesta 2014 - 2019 Service Manual / Engine / Engine System - General Information / Engine - Overview. Description and Operation

Engine Information

NOTE: When repairing engines, all parts must be contamination free. If contamination/foreign material is present when repairing an engine, premature engine failure may occur.

NOTE: Specifications show the expected minimum or maximum condition. Refer to the appropriate section in Group 303 for the specifications.

NOTE: If a component fails to meet the specifications, it is necessary to refinish it or install a new component. Wear limits are provided as an aid to determine if the component can be refinished. A new component must be installed when any component fails to meet specifications and cannot be refinished.

NOTE: This section contains information, steps and procedures that may not be specific to this engine.

This section covers general procedures and diagnosis and testing of the engine system, except for exhaust emission control devices, which are covered in the PC/ED .

The engine incorporates the following features: Refer to the appropriate section in Group 303 for the procedure.

  • Crankcase ventilation or breather system
  • Exhaust emission control system
  • EVAP control system

Some engines incorporate a fail-safe cooling system. Refer to the appropriate section in Group 303 for the procedure.

The engine, fuel system, ignition system, emissions system and exhaust system all affect exhaust emission levels and must be maintained according to the maintenance schedule. Refer to the Scheduled Maintenance Guide.

Correct engine identification is required to order parts. Refer to the appropriate section in Group 303 for the procedure.

For complete vehicle and engine identification codes,
Refer to: Identification Codes (100-01 Identification Codes, Description and Operation).

    Engine System - General Information

    ..

    Engine. Diagnosis and Testing

    Inspection and Verification - Engine Performance NOTE: There are 2 diagnostic paths that can be followed depending on the type of engine concern...

    Other information:

    Ford Fiesta 2014 - 2019 Service Manual: Body Panel Sectioning. General Procedures


    Special Tool(s) / General Equipment Resistance Spotwelding Equipment Plasma Cutter Air Body Saw MIG/MAG Welding Equipment Spot Weld Drill Bit Materials Name Specification Seam SealerTA-2-B, 3M™ 08308, LORD Fusor® 803DTM -  Repair NOTICE: Do not begin removal of the vehicle body side until the replacement pa..

    Ford Fiesta 2014 - 2019 Service Manual: Manifold Absolute Pressure (MAP) Sensor. Removal and Installation


    Removal NOTE: Removal steps in this procedure may contain installation details. Remove the engine appearance cover. Disconnect the electrical connector, remove the retainer and the MAP sensor. Torque: 27 lb.in (3 Nm) Installation To install, reverse the removal procedur..

    Categories

    Ride Height Measurement. General Procedures

    Special Tool(s) / General Equipment

    Surface Gauge

    Check

    Ride Height Measurement - Front

    NOTE: Make sure that the vehicle is positioned on a flat, level surface and the tires are inflated to the correct pressure. Vehicle should have a full tank of fuel.

    Ride height = 2-3
    Measurement 2
    Measurement 3
    Use the General Equipment: Surface Gauge

    read more

    Copyright © 2025 www.fofiesta7.com